PurpleAir Air Quality Sensor PA-I Indoor
PurpleAir sensors use a fan to draw air past a laser, causing reflections from any particles in the air. These reflections are used to count particles in six sizes between 0.3μm and 10μm diameter.
Using one second particle counts, estimated total mass for PM1.0, PM2.5 and PM10 is averaged by the PurpleAir Internet of Things (IOT) control board.
Readings are then uploaded to the cloud every 80 seconds or so where they are stored for download and display on the PurpleAir map.
Outdoor power supply with 33 foot leads:
Output Voltage: 5 Volt (V)
Output Current: 2 Amps (A)
DC Power Supply Requirements: Typ:5.0 Min:4.5 Max: 5.5 Volt (V)
Active Current: ≤200 Milliampere (mA)
Peak Current: ≤600 Milliampere (mA)
Working Temperature Range: -20~+60 °C (-4~+140 °F)
Working Humidity Range: 0~99%
Physical Size 85 x 125 Millimeter (mm)(3.5 x 5 Inches)
BME280: Pressure / Temperature / Humidity
Operation range (full accuracy)
Pressure: 300…1100 hPa
Temperature: -40…85 °C
Humidity sensor response time (τ63%): 1s
Accuracy tolerance: ± 3 % relative humidity
Hysteresis: ≤ 2 % relative humidity"
Dual laser particle counters for fault tolerance:
Range of measurement: 0.3~1.0; 1.0~2.5; 2.5~10 Micrometer (μm)
Counting Efficiency: firstname.lastname@example.orgμm 98%@>=0.5μm
Effective Range: 0~500 μg/m³
Maximum Range: * ≥1000 μg/m³
Resolution: 1 μg/m³
Maximum Consistency Error: ±10%@100~500μg/m³ ±10μg/m³@0~100μg/m³
Standard Volume: 0.1 Litre (L)
Single Response Time: ≤1 Second
Total Response Time: ≤10 Seconds
WiFi 2.4 GHz, supports WPA/WPA2
Wireless Standards: 802.11 b/g/n
802.11 b: +20 dBm
802.11 g: +17 dBm
802.11 n: +14 dBm
802.11 b: -91 dbm (11 Mbps)
802.11 g: -75 dbm (54 Mbps)
802.11 n: -72 dbm (MCS7)
Type of Antenna: External, IPEX Connector, Ceramic Chip
* Optional SD Card Slot and Real Time Clock:
Extremely accurate DS3231 real-time clock (RTC) incorporates a battery backup and maintains accurate time keeping when main power to the device is interrupted.
A built in microSD card slot takes microSD cards up to 64GB for storage that will never run out.
PurpleAir sensors receive firmware updates over the air when connected to the Internet.